NEC express5800 A2010b - Confirming System Information

8. SMASH-CLP
Chapter 3 Setup
8.13 Confirming System Information
This section describes how to confirm the system information (product, BIOS/BMC firmware revision, CPU, and
Memory) through the command line interface.
Tips
The values of the properties for items not supported by the server is not displayed for the
system information. Moreover, the values of the properties for items
supported with the
server might not be displayed according to a state of a power supply and
device installation
status.
Confirming Product Information
You can confirm the product information through the command line interface by entering the following basic
command at the command prompt.
show /admin1/system1
oemnec_serialnumber=Proto06
oemnec_modelnumber=NE3400-00Y
oemnec_productname=Express5800/A2040b
In the "Properties" section, the value of oemnec_productname property indicates "Model Name",
oemnec_modelnumber property indicates "Part / Model Number", and oemnec_serialnumber property indicates
"Product Serial Number". These properties for the product information are read-only.
Tips
The value of oemnec_productname indicates "Model Name", oemnec_modelnumber
indicates "Part / Model Number". The model name and the part / model number
depend on
product.
Important
Execution of the above-mentioned show command takes 5 minutes at the maximum,
although it is dependent on the system configuration.
Confirming System BIOS revision
You can confirm the System BIOS revision through the command line interface by entering the following basic
command at the command prompt.
show /admin1/system1/swid1
Example of display is as shown below.
ufip=/admin1/system1/swid1
Properties:
VersionString=5.6.0015
Verbs:
cd
exit
help
show
version
In this case, the System BIOS revision is displayed at the right side of "VersionString=" string in the "Properties"
section.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
430