8. SMASH-CLP
8.16.10
version
Syntax
version [<options>]
Description
The version command is used to display the version of the command line protocol specification which is
supported.
8.16.11
oemnecfailover
The oemnecfailover command is used to perform failover of BMC (change to master). Use this command to
switchover the roles of master and standby BMCs.
Syntax
oemnecfailover
Parameter
None
Executing this command resets both master BMC and standby BMC. Waiting for a
while (approx. 3 minutes), you can log in SMASH CLP on both master and standby
BMCs.
This command can be used only while the server is off-powered. Make sure that the server
is off-powered before issuing this command.
You can confirm on which management board (#1 or #2) the master BMC
System tab on web console.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
446
To Next Page
Loading...