NEC express5800 A2010b - Power Control

9. WS-Management
Chapter 3 Setup
9.2 Power Control
You can perform power control of the server as follows.
• Power ON
• Power OFF immediate
• Soft Shutdown
• Hard Reset
• Force Dump
• Power Cycle
Important
• Performing these operations while the operating system is running may cause
the loss of data in the server.
• Specify the IP address of EXPRESSSCOPE Engine SP3 on master BMC for
"IP_ADDRESS", and login user name and login password
for ”USERNAME/PASSWORD” in the example.
• Specify http or https for "PROTOCOL" in the example.
• Do not perform any operation on WS-
Management while any of the following is
running on Web console.
Tab
Menu screen
Buttons on dialog
Remote
Access
Power Control All buttons
System Operation
All buttons
Configuration IPv4 Property (Master) [Apply] button on Edit screen
IPv6 Property (Master)
[Apply] button on Edit screen
Service (Master) [Apply] button on Edit screen
Backup / Restore
[Backup], [Restore]
Update BMC [Update]
BIOS
Hardware Log [Download BMC Dump]
Device Online / Offline
[Apply] button on Edit screen
Diagnosis [Execute]
Tips
To perform power control with WS-Management, an Operator privilege or an Administrator
privilege is required.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
448