NEC express5800 A2010b - Processor (CPU); Installation; Setting Required after Installation

1. Installing / Removing Internal Options
Chapter 2 Preparations
1.12 Processor (CPU)
Your server can have up to four processors.
Important
Make sure to use the processor authorized by NEC. Installing a third-party processor
may cause a failure of the processor as well as t
he motherboard. Repair of the
server due to failures or damage resulted from installing such a processor will be
charged.
1.12.1 Installation
Ask your service representative who is authorized by NEC to install the component. The service representative
will install the component, and transfer the server to you after making sure that the server can operate normally.
1.12.2 Setting Required after installation
Run BIOS Setup Utility (SETUP) to confirm the settings related to CPU. Refer to Chapter 2 (1. System BIOS) in
"Maintenance Guide".
Advanced → Processor Configuration → Processor Information
– CPU ID
– L2 Cache RAM
– L3 Cache RAM
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
188