NEC express5800 A2010b - Connecting Power Cable

2. Installation and Connection
Chapter 2 Preparations
2.2.1
Connecting power cable
Take the steps below to connect power cable.
1. Insert the cable clamp (provided with power supply unit) into the power supply unit, as shown in the
figure below.
2. Insert the power cable into AC inlet of power supply unit.
3. Secure the power cable with cable clamp to prevent the cable from disconnecting.
Cable clamp
Cable clamp
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
245