NEC express5800 A2010b - Smash-Clp; Overview; Connecting to BMC

8. SMASH-CLP
Chapter 3 Setup
8. SMASH-CLP
8.1 Overview
With the BMC Command Line Interface, you can control the server from a remote SSH client.
The BMC supports SSH (Version 2) protocol.
8.2 Connecting to BMC
Access the BMC IP address (MLAN IP address for user maintenance or IP address of maintenance LAN) or
DNS host name from SSH client on the remote management PC. The BMC default IP address is 192.168.1.100.
Important
To use Command Line Interface, you need to enable command line interface (feature
to be used in SSH) by using BMC Configuration of Off-line/On-
line TOOL or setting
on web browser. See (7.7.1 BMC (1) Network (a)
IPv4 Property (Master)) for how to
configure.
Tips
• You can change the BMC’s SSH port number by using the BMC Configuration of
Off-line/On-line Tool, or a web browser. The default settings is as follows:
SSH: 22
• A security warning messages regarding your server certificate may be displayed when
you access the BMC from a SSH client.
• SSH connection is disconnected automatically after one minute of inactivity after login
prompt is displayed.
BMC#1
(Master BMC)
BMC#2
(Standby BMC)
MLAN for maintenance
MLAN for user maintenance
User terminal
Default IP address:
192.168.1.100
Default IP address:
192.168.1.101
Terminal for
maintenance
personnel
Default IP address:
169.254. 255.254
Default IP address:
169.254. 255.254
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
408