8. SMASH-CLP
8.9.3
Setting access log
Enter the following command at the command prompt to move the current default target to /admin1/sp1/log1.
cd /admin1/sp1/log1
Enter the following command to show the settings that access log contains as properties.
show
Enter the following command to modify the setting of access log.
set <property>=<new value>
The properties that can be viewed and modified are as follows:
• oemnec_operationlog_enable
This specifies whether access log for the system control and the setting modification via Web browser is
enabled.
oemnec_operationlog_enable=2 : Access log is enabled.
oemnec_operationlog_enable=3 : Access log is disabled.
• oemnec_sshlog_enable
This specifies whether access log for login/logout of SSH is enabled.
oemnec_sshlog_enable=2 : Access log is enabled.
oemnec_sshlog_enable=3 : Access log is disabled.
• oemnec_httpslog_enable
This specifies whether access log for login/logout of HTTPS is enabled.
oemnec_httpslog_enable=2 : Access log is enabled.
oemnec_httpslog_enable=3 : Access log is disabled.
• oemnec_httplog_enable
This specifies whether access log for login/logout of HTTPS is enabled.
oemnec_httplog_enable=2 : Access log is enabled.
oemnec_httplog_enable=3 : Access log is disabled.
An example of setting is shown below.
Example: To enable the setting of access log related to login/logout of HTTPS.
set oemnec_httpslog_enable=2
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
423
To Next Page
Loading...