1. Installing / Removing Internal Options
5. Refer to Steps 6 to 10 in Chapter 2 (1.4 Overview of Installation and Removal) to check if work is
successfully completed.
6. If you installed component offline (while the server is off-powered), perform diagnostic test according to
Chapter 1 (1.8 System Diagnostic) in Maintenance Guide.
7. Cancel the maintenance mode you have set in Step 1. (See Chapter 3 (7.7.1 BMC – (7) Extended
Functionality) for how to cancel the maintenance mode. If the UID LED is on, turn off the UID LED using
UID switch.
1.7.2
Removal
Take the steps below to remove the optical disk drive.
1. Set to the maintenance mode. See Chapter 3 (7.7.1 BMC – (7) Extended Functionality) for details.
2. Refer to Steps 3 to 4 in Chapter 2 (1.4 Overview of Installation and Removal) for preparations.
3. Push the lock levers on both sides of optical disk drive toward inside.
4. Pull the optical disk drive toward front while pushing the lock levers (as described in Step 3).
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
166
To Next Page
Loading...