NEC express5800 A2010b - Force Dump

9. WS-Management
Chapter 3 Setup
9.2.5
Force Dump
To use WinRM, create a file input-RequestPowerStateChange11.xml, and run the following command to issue
a RequestPowerStateChange of its PowerState is 11 (Diagnostic Interrupt (NMI)) to BMC.
winrm invoke RequestPowerStateChange
"http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_PowerManagementService?__cimnamespac
e=root/cimv2+Name=IPMI Power
Service+CreationClassName=CIM_PowerManagementService+SystemName=Unknown.IPMI BMC
DeviceID.5B+SystemCreationClassName=Host_ComputerSystem" -r:PROTOCOL:// IP_ADDRESS /wsman
-username: USERNAME -password: PASSWORD -auth:basic -encoding:utf-8 -skipCAcheck -skipCNcheck
-skipRevocationcheck -format:xml -file:input-RequestPowerStateChange11.xml
input-RequestPowerStateChange11.xml
<n1:RequestPowerStateChange_INPUT
xmlns:n1="http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_PowerManagementService"
xmlns:wsa="http://schemas.xmlsoap.org/ws/2004/08/addressing"
xmlns:wsman="http://schemas.dmtf.org/wbem/wsman/1/wsman.xsd">
<n1:PowerState>11</n1:PowerState>
<n1:ManagedElement>
<wsa:ReferenceParameters>
<wsman:ResourceURI>http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/Host_ComputerSystem
</wsman:ResourceURI>
<wsman:SelectorSet>
<wsman:Selector Name='__cimnamespace'>root/cimv2</wsman:Selector>
<wsman:Selector Name='CreationClassName'>Host_ComputerSystem</wsman:Selector>
<wsman:Selector Name='Name'>Unknown.IPMI BMC DeviceID.5B</wsman:Selector>
</wsman:SelectorSet>
</wsa:ReferenceParameters>
</n1:ManagedElement>
</n1:RequestPowerStateChange_INPUT>
Tips
• This operation is equivalent to performing Remote Access → System Operation →
DUMP (NMI) on Web console.
• Performing these operations while the operating system is running may cause the loss
of data in the server.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
453