NEC express5800 A2010b - Displaying Specified Sensor

9. WS-Management
Chapter 3 Setup
9.3.2
Displaying Specified Sensor
You can display the sensor data by specifying sensor number.
Run the following command to display the sensor data of sensor number 0 that has threshold value by using
WinRM.
winrm get
"http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_NumericSensor?SystemCreationClassNam
e=CIM_ComputerSystem+CreationClassName=CIM_NumericSensor+SystemName=Unknown.IPMI BMC
DeviceID.5B+DeviceID=1.0.0.32.1.99" -r:PROTOCOL://IP_ADDRESS/wsman -username:USERNAME
-password:PASSWORD -auth:basic -encoding:utf-8 -skipCAcheck -skipCNcheck -skipRevocationcheck
Run the following command to display the sensor data of sensor number 1 that does not have threshold value
by using WinRM.
winrm get
"http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_Sensor?SystemCreationClassName=CIM_C
omputerSystem+CreationClassName=CIM_Sensor+SystemName=Unknown.IPMI BMC DeviceID.5B+DeviceID=
2.1.0.32.b.0" -r:PROTOCOL://IP_ADDRESS/wsman -username:USERNAME -password:PASSWORD -auth:basic
-encoding:utf-8 -skipCAcheck -skipCNcheck -skipRevocationcheck
Important
• Specify the IP address of EXPRESSSCOPE Engine SP3 for "IP_ADDRESS", and
login user name and login password for ”USERNAME/PASSWORD”
in the
example.
• Specify http or https for "PROTOCOL" in the example.
• Specify ”Unknown.IPMI BMC DeviceID.5B” for <SystemName>.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
456