NEC express5800 A2010b - Page 262

4. BIOS Setup Utility (SETUP)
Chapter 3 Setup
Password
If you have set a password, a message prompt you to enter password will be displayed from the next time.
Enter password [ ]
You can attempt password entry up to 3 times. If you entered an incorrect password 3 times, operation
stops. (You cannot operate further.) Turn off the power.
Saving changes
If you finish configuration, select Save & Exit and then Save Changes and Exit to save changes and exit.
If you wish to exit without saving the changed parameters, select Save & Exit and then Discard Changes
and Exit.
Or if you wish to restore the setting to default values, select Save & Exit
and then Load Setup Defaults.
(The default value might be different from the factory setting.)
Note
You can also restore the setting to default values by using "Reset Param BIOS" feature of
Remote Management. If this feature is used, n
ot only BIOS settings but also OS boot
entr
y is cleared. To recover OS boot entry, restore the configuration file backed up by
using Backup/Restore feature of Remote Management or set it again with the tool on OS.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
262