5. EXPRESSSCOPE Engine SP3
6. The screen as shown below appears when [IPv4 Property] is selected. Specify [Enable] when using
DHCP server. Specify [Disable] when not using DHCP server. If you select [Disable] for DHCP, specify
IP Address, Subnet Mask, and other items.
If you select <OK>, the settings made here is applied to BMC.
7. Connect LAN cable to management LAN port to connect with network. Access the web console from
web browser on remote terminal according to settings.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
271
To Next Page
Loading...