5. EXPRESSSCOPE Engine SP3
(r) Remote media FD access LED
The access LED may keep go on after the floppy disk drive is connected to remote terminal, depending on drive
type.
(s) Use EXPRESSBUILDER via remote media
Once disconnect remote media when you need to replace CD/DVD-ROM media during remote media
connected. Then replace the CD/DVD-ROM media with a new one and connect remote media again.
If you don’t disconnect the remote media once, the new CD/DVD-ROM media might be recognized.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
278
To Next Page
Loading...