NEC express5800 A2010b - Page 364

7. Using Remote Management
Chapter 3 Setup
Reference
The following table shows reference values of power consumption depending on configuration and running
status of the managed server.
Item name
Setup value
Maximum Power Consumption (*1)
Power consumption depending on configuration and running status
Minimum Power Consumption (*1)
Power consumption depending on configuration and running status
(*1) These values are reference only. Actual value depends on your server configuration.
Power
Shows current power consumption of managed server.
Item name
Statistics
Current
Current power consumption
Proactive Mode
Use this mode to control power consumption of the server not exceeding the upper limit. In this mode, power
consumption is reduced by changing CPU clock speed to lower the system performance.
Item name
Description
Setup value
Default
Proactive Mode
Enable or disable Proactive
Mode.
Enable/Disable
Disable
Power Threshold
(Pa)
Specify threshold value in
Proactive Mode.
AAA to Maximum Power
Consumption [W](*1)
When Alert Mode is Enabled, AAA
is the value specified in Alert Mode
Power Threshold (Pn).
When Alert Mode is Disable, AAA is
the minimum power consumption.
Maximum Power
Consumption (*1)
(*1) Allowable range of (Minimum Power Consumption to Maximum Power Consumption)[W] depends on
server model. (The default value indicates the maximum value in allowable range.)
Important
• If this mode is specified during OS running, it is applied immediately. If this
mode is specified while the DC power is off, it is applied at the next OS bootup.
• Do not specify this mode during the time between DC OFF to OS startup.
• When the operator privilege user moves to this page, ‘Failed to access BMC.’
diag
pops up, and nothing is displayed on the settings value. Administrator
privilege is required to refer or modify settings.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
364