NEC express5800 A2010b - Page 380

7. Using Remote Management
Chapter 3 Setup
Update procedure
1. Press the [Browse] button to select an image file used for update.
2. Pressing the [Start Update] button starts update.
3. You can check the progress of update by viewing message displayed on Update Status field. When
update completes, "Update completed" is displayed.
Important
• If update is performed while the DC power is off, BMC is reset 60 seconds later
and restarted with new firmware re
gardless of the checkmark on "Apply
immediate" check box.
• If update is performed while the DC power is on,
BMC is reset automatically at
next power-off of server, and restarts with the new firmware.
• Clear the cache of the Web browser after the update completed.
Buttons
① [Browse] button
Press the [Browse] button to select an image file used for update.
② [Apply immediate]
When the server is in power-off state, or server is in power-on state and [Apply immediate] is being checked,
BMC is reset automatically 60 seconds after completion of update.
③ [Start update] button
Press the [Start update] button to start update.
④ [Reload] button
Press the [Reload] button to display the latest information.
Important
The Security Warning of Java as shown below may appear when update is started. In
this case, be sure to select [Don't Block]. If you select [Block], update will fail.
To hide popup message as shown below, select [Control Panel]
→
[Java]
→
[Advanced]
→
[Mixed Code (sandbox vs. trusted) security verification], and ch
eck to
[Enable - hide warning and run with protections].
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
380