NEC express5800 A2010b - Page 391

7. Using Remote Management
Chapter 3 Setup
Edit page
The components selectable in Component Type and Component Selection fields are shown below. To perform
Online operation, check to [Online]. To perform Offline operation, check to [Offline].
For Online operation, you can select MR or PCIe card in Component Type field. The target component can be
selected from Component Selection list.
Component Type
Component Name (*1)
Default setting(*2)
Online Operation
Memory Riser
1 to 8(*1)
1(*1)(*3)
PCIe Card
1 to 16(*1)
1(*1)
Offline Operation
PCIe Card
1 to 16(*1)
1(*1)
(*1) Only the selectable components are displayed.
(*2) Factory-set value.
(*3) If you press the [Default] button, "Online - Memory Riser" is selected.
Tips
"None" is displayed in [Component Selection] list if no spare hardware component is
available.
Important
• The operations must be performed only while the server is powered on.
• MR or PCIe card must be inserted into the relevant slot before performing Online
operation.
• Before performing Online/Offline operation
of PCIe card, select [Configuration]
tab and click [Extended Functionality] in menu tree to check if "Dynamic" is
selected for "Spare PCIe Configuration Mode". If not, change it [Dynamic].
• MR Online requires the installations of the dedicated software.
Before
performing MR online, the target MR and the total capacity of DIMMs on the MR
must be specified by the software. Refer to "MR Hot-
Add User's Guide" on
http://www.58support.nec.co.jp/global/download/index.html.
• Before performing Online/Offline operation of MR, select [Configuration] tab and
click [Extended Functionality] in menu tree to check if "Dynamic" is selected
for "Spare Memory Configuration Mode". If not, change it [Dynamic].



Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
391