NEC express5800 A2010b - Page 439

8. SMASH-CLP
Chapter 3 Setup
• oemnec_OpRomMonitoring
Use this property to specify whether the monitoring timeout of OpROM stall is enabled or disabled. The
setting can be changed by set command.
• oemnec_FailureFlowMonitoring
Use this property to specify whether the server is rebooted automatically after fatal error occurred.
• oemnec_Shutdownonitoring
Use this property to specify whether the monitoring timeout of OS Shutdown stall is enabled or disabled and
its monitoring duration when enabled.
• oemnec_CoreAssignMode
Use this property to specify whether the cores are assigned equally to sockets.
Type1: Cores are not assigned equally to each socket.
Type2: Cores are assigned equally to each socket.
• oemnec_SpareCoreOptimizationMode
Use this property to specify core assign mode.
centralized: Cores are enabled on each socket intensively. Accordingly, the number of enabled cores
may deviated in each core.
decentralized: Enabled cores are distributed to each socket.
• oemnec_SpareCoreConfigurationMode
Specify the configuration mode for spare core.
dynamic: Cores are enabled (codeword is set) while the OS is running.
static: Cores are enabled while the OS is not running.
• oemnec_DisableCoreNumber
Specify the number of cores to be disabled.
Import
ant
• With A2010b and A2020b models, viewing and configuring
"oemnec_SpareCoreOptimizationMode" and
"oemnec_SpareCoreConfigurationMode" properties are not supported.
"N/A" is displayed against the show command.
• With A1040b model, viewing and configuring
"oemnec_SpareCoreConfigurationMode" property is not supported.
"N/A" is displayed against the show command.
• oemnec_CoolingTimeExtension
Use this property to specify whether the cooling time at power-off should be extended or not.
enabled: Extends cooling time between power-off and power-on status.
disabled: Does not extend cooling time between power-off and power-on status.
• oemnec_ProactivePowerCappingRange
If Proactive mode is enabled, this property shows modifiable power consumption range by wattage. This
property is read only.
modifiable power consumption range: modifiable minimum power consumption value[W] - modifiable power
consumption value[W]。
Ex: oemnec_ProactivePowerCappingRange = 549[W] - 2085[W]
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
439