NEC express5800 A2010b - Page 489

2. Operation Mode
Chapter 4 Appendix
Operation mode
Parameter
([ ]: Default setting)
When
applied
Description
Core Assign Mode
[Type1]: Does not assign
equally.
Type2: Assigns equally.
At next boot Specify whether cores are assigned equally to
each CPU sockets.
Others
Configuration menu
→
Miscellaneous
Operation mode
Parameter
([ ]: Default setting)
When
applied
Description
SEL [Stop logging SEL]
Clear All SEL
Overwrite oldest SEL
Immediate Specify the logging method of new event log
(SEL) when SEL repository is full.
Stop logging SEL: New event is not logged when
SEL repository is full. This setting can be used
on the server where NEC ESMPRO Agent is
installed. NEC ESMPRO Agent takes up SEL,
and then clears SEL. If NEC ESMPRO Agent is
not installed, new event log cannot be collected.
Clear All SEL: All the event logs are cleared
when SEL repository becomes full.
Overwrite oldest SEL: The oldest log is
overwritten by new log when SEL repository is
full.
Power Option /
AC-LINK
Stay Off
[Last State]
Power On
At next boot Specify whether AC-LINK feature is enabled or
not.
Stay Off: Does not perform DC On automatically
after AC-On.
Last State: Restore the DC state before AC-Off.
Normally, AC-Off is performed while in DC Off
state. Accordingly, DC On is not performed
automatically in this case. However, if AC power
is lost due to disconnecting AC cable by mistake
or failure of PSU, DC On is performed
automatically after AC power is turned on next
time.
Power On: Perform DC On automatically after
AC-On.
Power Option /
Delay time
Random
[Manual Setting (45)]
At next boot Specify the time to start AC Link.With this
setting, delay time can be set if "Power On" is
specified for AC Link.
Random: BMC sets random value not exceeding
600 seconds.
Manual Setting: Select this item to set delay time
manually. Available values are between 0 and
600 seconds.
PEF/
Platform Event
Filtering
[Enable]
Disable
Immediate Enable or disable SNMP trap (PEF).
If Disabled, SNMP alert is not sent. If you want
to receive SNMP alert, set this item to Enable.
Management Software
/ ESMPRO
Management
[Enable]
Disable
Immediate Enable or disable the feature to monitor or
manage the server from NEC ESMPRO
Manager.
If Enabled, NEC ESMPRO Manager can
remotely monitor or manage the server.
Management Software
/ Redirection (LAN)
[Enable]
Disable
Immediate Enable or disable the feature to display
SerialOverLan (SOL) page from NEC ESMPRO
Manager.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
489