CHAPTER 3 SYSTEM DATA PROGRAMMING
– 329 – NWA-008853-001 Rev.3.0
97ch3005.fm
• For Main Office
COT: When using a COT interface between the Central Office and a Main Office, set up program-
ming to the Main Office by using the DIT-CCIS feature, and send the dial code as an LDN to
the Satellite Office. Refer to programming of DIT-CCIS in this chapter for details.
DID: When using a DID interface between the Central Office and the Main Office, there are two pro-
gramming patterns:
Pattern 1 When an incoming LDN call is diverted to a Satellite Office in both Day Mode and Night
Mode, program by using the LCR and uniform numbering features. Refer to Numbering Plan
Assignment.
Pattern 2 When an incoming LDN call is diverted to a Satellite Office in either Day Mode or Night Mode
(not both), the following programming for the LDN Diversion-Outside feature is required.
DESCRIPTION DATA
Provide the system with the Diversion Display
and the LDN Diversion features.
(1)
(2)
204: Diversion Display
0: To provide
(1)
(2)
205: LDN Diversion
0: To provide
Assign the indialed number to each TIE key on
the ATTCON. The indialed number should be
different from any numbers assigned by
CM10/CM14 and CM11.
•
(1)
(2)
Y=01
1-8: LDN key No.
X-XXXX: Indialed No.
Assign the data for LDN Diversion to each in-
dialed number assigned by CM50 Y=01.
•
(1)
(2)
Y=00 Tenant No.
01-08: LDN 0-7 assigned by CM50 Y=01
00-63: TAS Group
•
(1)
(2)
Y=02 Day Mode Destination
01-08: LDN 0-7 assigned by CM50 Y=01
09: LDN Diversion-Outside
(Assigned by CM58 Y=08)
START
CM08
CM50
CM58
A
TRUNK ANSWER FROM ANY STATION-CCIS
To Next Page
Loading...
