NEC SL1100 - Page 183

NEC SL1100 Issue 6.0
Networking Manual 9 - 49
10-46-01
DR700 Server
Information Setup
– Register Mode
Define which of the three
Registration modes you wish the
SIP MLTs to use.
Plug and Play
When the phone boots up it will
report the ext assigned in the
phone or choose the next available
extension in the system. No
password required.
Auto
If set to auto then the SIP user
name and password must be
entered into the actual IP phone.
These settings have to match
Programs 84-22/15-05-27 or the
phone does not come on-line.
Manual
When the phone boots up it
prompts you to enter a user ID and
password before logging in. It
checks this user ID/password
against Programs 84-22/15-05-27.
If there is not a match, the phone
does not come on-line.
0 = Plug and Play
1 = Automatic
2 = Manual
Default is 0
X
10-46-04
DR700 Server
Information Setup
– Server Name
USER ID of the SIP URL if
Program 10-46-05 is set to domain
name.
A SIP URL is made up of three
parts. Domain name, host name,
and server name.
e.g. At default the server name is
sipphd. The URL could look like
the following:
sipphd@voipu.nec.com
Up to 32 characters.
Default is sipphd
X
10-46-06
DR700 Server
Information Setup
– Register Port
Port the SIP messages are sent to
on the VoIPU card. This same
port number must be assigned in
the SIP Multiline terminals.
Changing this command also
requires a CPU reset.
Range = 0 ~ 65535
Default is 5080
X
Program
Number
Program Name Description/Comments Assigned Data 1 2 3