NEC SL1100 - Page 234

Issue 6.0 NEC SL1100
11 - 4 NAPT
Setting location: 0. Config/ 2. SIP Settings/ 8. NAT Traversal/ 3. WAN
Settings
Setting location: 0. Config/ 1. Network Settings/ 6. Advanced
Settings/ 5. Self Port Settings
3.WAN
Settings
See table below.
Number and
Name of
Setting
Setting
Value
Default
Value
Factory
Value
Auto
Config
Description
1. WAN Mate
IP Address
IP Address 0.0.0.0 Available Available WAN Address of the router that the
SL1100 resides behind. This setting
must match what is programmed in PRG
10-12-07.
2. WAN SIP
Mate Port
1024~65535 5060 Available Available Port number the SL1100 uses for SIP
registration in PRG 10-46-06.
3. WAN Self IP
Address
IP Address 0.0.0.0 Available Available Only used when Static NAT is enabled.
This setting is the WAN address of the
router that the NAPT Terminal resides
behind.
Number and
Name of
Setting
Setting Value
Default
Value
Factory
Value
Auto Config Description
1. RTP Self
Port
1024~65528
(Even numbers
only)
3462 Available Not available The number of the port receiving RTP
data.
At default this is assigned to port 5060.
The First IP phone on this local LAN can
use this port. The second IP phone
would need to be changed to port 5062.
2. SIP Self Port 1024~65535 5060 Available Not available The number of the port receiving SIP
data.
At default this is assigned to port 3462.
The first IP phone on this local LAN can
use this port. The second IP phone
would need to be changed to port 3464.
Number
and Name
of Setting
Setting
Value
Default
Value
Factory
Value
Auto
Config
Description