Netafim nmc-pro - Multiple Water Meters; Option a - Standard Use;Measurement; Option B - Multiple Water Sources

NMC-PRO Installation Manual
131Page
CONTROLLER ADVANCED SETTINGS
13.2 Multiple Water Meters
• Option A - Standard Use/Measurement
• Option B - Multiple Water Sources
13.2.1 Option A - Standard Use/Measurement
13.2.2 Option B - Multiple Water Sources
This option is used for water management, meters are located before the irrigation system.

NOTE: Cannot allocate a water meter to a valve.
The controller will simulate a virtual water meter with a calculated flow of WM1+WM2+WM3-WM4.
Enter capacity and type for
additional water meters
Configure meters to
valves
Ex: Valves 3, 4 & 5 are
allocated to water
meters 2, 3 & 4
consecutively
Only 1 water meter can be measured at a time.
Tank 1
Tank
2
Water
Drain
Water
Water Meter 1
Water
Meter 2
Water
Meter 3
Water
Meter 4
1
2
3
4
5