NMC-PRO Installation Manual
98Page
10.1 Time & Date
The Time & Date screen allows you to set the current time and date as well as the end of the crop daytime.
To adjust the time and date, place the cursor on the setting you wish to modify, change the numbers using the keypad
and press ENTER to save your changes.
• End Day Time: Select the start time of a new day 00:00 to 23:00. At End Day time:
All the alarms are reset.
All the uncompleted irrigations are reset. Irrigation cycles that haven’t been completed will move to the
Uncompleted Programs table, page 88.
All the valves that are registered in the uncompleted programs table and did not complete the irrigation
are switched from Wait position to Do Not Continue (Move to history).
Cycle days in the PROGRAM table are moved one day ahead.
The daily % change is zeroed (the constant % change stays the same).
Currently active cycle will continue with its current settings until completed.
• Start/End time for VPD Sum – Set the time frame for the VPD Sum counter.
Only during this time frame will the VPD be summed
At End time for VPD Sum, the counter is reset
10.2 System Setup
The System Setup screen includes all general system settings.
To Next Page
Loading...
Need help?
General
