NMC-PRO Installation Manual
87Page
8.3 Uncompleted Irrigation
The Uncompleted Irrigation table provides information of irrigations that were started but could not be completed due
to a failure. To understand why an irrigation was not completed it is advisable to cross-reference between this table
and the Alarm History table, page 79. The Uncompleted Irrigation table consists of up to 200 lines. Note that if the
letter 'C' appears, it refers to a program that was triggered by condition program.
Each line includes information regarding when the irrigation was stopped and added to the uncompleted irrigations
table.
• Date: Date in which the current line was added to the uncompleted irrigation table.
• Time: Time in which the current line was added to the uncompleted irrigation table.
• Prog. No.: Program number.
92: The program that was added to the table was started manually.
93: The relevant irrigation was added to the uncompleted irrigations table for the second time (or more)
consecutively.
• Vl. No.: Indicates the associated valve. If a group of valves that is configured to irrigate together is stopped,
only the first valve is written but a ‘+’ sign is added next to it to indicate that more valves are associated. The
NMC-Pro will attempt to complete the irrigations from the current day (until end day time) upon manual or
automatic alarm reset.
The valve column of irrigations that are to be completed will be highlighted.
The valve column of irrigations that are currently being completed will blink.
• Run No.: Indicates the associated run time program.
• Dose Prog.: Indicates the associated dosing program.
• Prog. Qty.: Planned quantity according to the run time program.
• Left Qty.: Uncompleted quantity.
To manually stop an uncompleted irrigation, go to the Start/Stop Valve table, page 77 because the activation is
according to single valves.
To Next Page
Loading...
Need help?
General
