NMC-PRO Installation Manual
88Page
8.4 Uncompleted Programs
The Uncompleted Programs table provides information on programs that could not be completed. It is important to
understand the difference between this table and the Uncompleted Irrigations table; this table consists only of
irrigation cycles that haven’t been started and could not be completed during the current day. This can happen due to
wrong system setup (more tasks than could be completed), or because the system was not active for a long period of
time, for example due to a power failure, and could not complete its tasks.
The uncompleted program table consists of 200 lines.
8.5 Daily Irrigation
This table allows you to view history of irrigation quantities or time per valve.
Press ENTER to open the selection list, move with the arrow keys to the relevant day and confirm your choice by
pressing ENTER.
For example, 1 day ago means you would like to view yesterday's history, and Today means you would like to view
the accumulated history since the last End Day.
The relevant date you are currently viewing will be displayed at the top of the screen.
The Daily Irrigation table contains all water (m3 or gallon) and dosing (liter or gallon). To toggle the view between
quantities and time, press the ‘+/-‘ key.
To Next Page
Loading...
Need help?
General
