Netafim nmc-pro - Water Run Time

NMC-PRO Installation Manual
65Page
PROGRAM MENU
5.3 Water Run Time
The WATER RUN TIME table has 60 “floating” programs; each program can be configured so that irrigation water is
given in time (HH:MM:SS) or in quantity (m
3
or gallon, depending on definitions in the System Setup, page 98). The
programs can later be connected to a valve or a group of valves through the Irrigation Program. Each program
includes water, water before and water after settings.
• Method: Select the method (QTY. Or Time) with the up/down arrow keys and press ENTER to confirm.
• Water: Set quantity / time for each program (liter or gallon). The water setting is the total quantity / time
including the Before and After settings.
• Before: Set quantity/time without dosing at the beginning of each irrigation cycle.
• After: Set quantity/time without dosing at the end of each irrigation cycle.

Note: Before and After settings are deducted from the Water settings. Therefore Water quantity/time must be
larger or equal to the Before and After settings.
DATE: 2 –Feb-12 TIME 12:52-08
IRRIGATION PROGRAM
Program: 1
Priority: --
Const. 0%
INFLUENCE
PRIORITY
ACTIVE/SOURCE
Radia./EC
Temp
EC
Drain/RadS
(°C/F))
(%)
Drain/MinT
25
2
EC Drain/EC
27
5
VPD/EC
30
7
Temp/EC
Screen 2 of 2 – In order to view the