Netafim nmc-pro Installation Guide

NMC-PRO Installation Manual
64Page
PROGRAM MENU
5.2.2.6 Temperature Influence on Target EC
You can adjust the EC based on the air temperature. As the temperature rises or falls, the program can increase or
decrease the EC level according to your requirements.
1. In Installation > Analog Input:
a. Define a sensor as EC
b. Define an air temperature sensor

Note: You can verify the EC status using Hot Key Screen 4 and the temperature sensor status using Hot Key
Screen 6.
2. In Configuration > Dosing Channel Configuration set React to EC.
3. In Configuration > Dosing Configuration > EC Control, set EC Control to Yes.
4. In Program > Irrigation, select Temp/EC.
a. Define the Temperature sum points.
b. Define the EC percentage set points.
5. Set ACTIVE/SOURCE, select the temperature sensor number.
6. In Program > Dosing Program:
a. Set the Target EC
b. Set EC Dosing Method to Pr. Qty.
Example: A grower’s flower crop requires higher EC levels when the temperature goes above room temperature
(22° C). Using this screen, he can adjust the levels accordingly.
DATE: 2 –Feb-12 TIME 12:52-08
IRRIGATION PROGRAM
Program: 1
Priority: --
NO
0%
INFLUENCE
TABLE
OUT temp
Temp 1
Radia./EC
Temp 2
Drain/RadS
Temp 3
Drain/MinT
Temp 4
EC Drain/EC
N/A
VPD/EC
NO
Temp/EC
NO
Screen 2 of 2 – In order to view the
DATE: 2 –Feb-12 TIME 12:52-08
IRRIGATION PROGRAM
Program: 1
Priority: --
Const. 0%
INFLUENCE
TABLE
ACTIVE/SOURCE
Radia./EC
VPD
EC
Drain/RadS
(kPa)
(%)
Drain/MinT
15
7
EC Drain/EC
10
4
VPD/EC
5
2
Temp/EC
Screen 2 of 2 – In order to view the

Netafim nmc-pro Specifications

General

Brand	Netafim
Model	nmc-pro
Category	Controller
Language	English