Netafim nmc-pro Installation Guide

NMC-PRO Installation Manual
51Page
ELECTRICAL INSTALLATION

Note: For different dosing settings, refer to NMC Pro Advanced Settings
4.7.9 EC/PH Sensor Range

Note: When using multiple EC or pH sensors, refer to NMC-Pro Advanced Settings
4.7.10 History Resolution

Note: For more details on system setup, refer to NMC-Pro Advanced Settings
DOSING CONFIGURATION
EC Control
YES
pH Control
YES
EC Alarms
YES
pH Alarms
YES
Minimum On Time (sec)
0.8
Minimum Off Time (sec)
0.8
EC Coarse Tuning
5
EC Fine Tuning
5
pH Coarse Tuning
5
pH Fine Tuning
5
Control Cycle EC
4
Control Cycle pH
4
EC/pH Averaging (0-Low, 20-High)
3
Dosing Boost Off Delay (mm:ss)
00:02
Dosing by QTY. Method
SPREAD
CONFIGURATION
1. DEVICE DELAY CONFIGURATION
2. PUMP STATION CONFIGURAITON
3. VALVE CONFIGURATION
4. VALVE FLOW RATE
5. WATER METER
6. DOSING CHANNEL CONFIGURATION
7. DOSING CONFIGURATION
8. EC PRE-CONTROL CONFIGURATION
9. DRAINAGE CONFIGURATION
10. SYSTEM PRESSURE CONFIGURATION

Netafim nmc-pro Specifications

General

Brand	Netafim
Model	nmc-pro
Category	Controller
Language	English