NMC-PRO Installation Manual
99Page
• Language: Choose controller language.
• Temperature Unit: Celsius or Fahrenheit.
• Volume Unit: Metric (m3 & Liter) or Gallon. These units also influence the pressure measurement units; when
choosing metric pressure, measurement will be in bar, when choosing gallon pressure, measurement will be
in PSI.
• Maximum Cooling Parallel: Define the maximum number of cooling programs to be operated
simultaneously. The maximal possible number is 8.
Note: This number refers to the number of cooling programs that will be operated in parallel; valves from the same
cooling program will always be operated sequentially.
• Maximum Misting Parallel: Define the maximum number of misting valves to be operated simultaneously.
The maximal possible number is 40.
STOP IRRIGATION
• During Filter Flushing: Define whether irrigation should be stopped during filter flushing.
• During Cooling Process: Define whether irrigation should be stopped during cooling.
• During Misting Process: Define whether irrigation should be stopped during misting.
STOP DOSING
• During Filter Flushing: Define whether dosing should be stopped during filter flushing.
MAIN SCREEN
• Default Hotkey Number: Define the required default hotkey number. When the system is idle for a few
minutes the controller will automatically switch to the default hotkey (hot-screen)
HISTORY
• History Resolution: Set the history collection rate of the sensors. For example if set to 15 minutes, the
controller will collect data from the defined sensors every 15 minutes (see 10.8 Sensors Logging for
configuring which sensors / data is collected).
To Next Page
Loading...
Need help?
General
