1.3 Features
DP Series/DP Series Type R
5
Various interfaces to address a variety of usage
The interface to use for the remote controlling from a computer or sequencer is equipped. USB and
RS232 interface are standard, and either GPIB or LAN (LXI 1.4) interface can be chosen when
ordering. You can use a contact/TTL signal to turn the output on/off or switch the memory without
using a computer. The product also offers the status output for showing the device status and the
output which is synchronized with Sequence or Simulation step. With these functions you can
achieve various types of systemization and automatization. The AGC function and Autocal function
for calibrating the output voltage drop are also provided.
Variable current limiter
This function can limit the effective value and the positive/negative peak value of the output current
where the limiting value is variable. You can set the limiter so that the output is turned off when the
limited condition continues for a certain time.
Power input
This product of single-phase input supports a wide range of power input from 100 V to 230 V.
However, with the model of which the output capacity is 6 kVA or more, the output power capacity
will be limited when the power input is 170 V or less. For the model of which the output capacity is
4.5 kVA or more, it is powered from the single-phase mains or the three-phase three-wire mains or
the three-phase four-wire mains, any of which can be chosen when ordering.
Feature-rich measurement function
On the panel the product displays the effective value, peak value, average DC value, current
peak-hold value, and active/apparent power of the output voltage/current. Furthermore, the power
factor, crest factor, reactive power, and harmonic current are also measured and displayed.
Control Software included by default
You can perform the following operations by using Control Software included in the attached
CD-ROM:
Operations same as those performed on the control panel
Editing/transferring/exporting* the arbitrary waveform data
Data logging (importing the measured values)
Editing/transferring/exporting*/performing Sequence
Editing/transferring/exporting*/performing Simulation
*Exporting the data to USB memory allows the data to be set to DP series/DP series Type R.
USB memory support (supported format type: FAT32)
You can write/read the following data to/from a commercial USB memory stick:
Basic setting
Sequence
Simulation
Arbitrary waveform
To Next Page
Loading...