Nikon D300S - Using the Built-In Flash

Using the Built-in Flash
Follow these steps when using the built-in flash.
1 Choose a metering method
(CD 102).
Select matrix or center-weighted
metering to activate i-TTL balanced fill-
flash
for digital SLR. Standard i-TTL flash
for
digital SLR is activated automatically
when spot metering is selected.
2 Press the flash pop-up button.
The built-in flash will pop up and begin
charging. When
the flash is fully
charged, the flash-ready indicator (~)
will light.
3 Choose a flash mode.
Press the ~ button and rotate
the main command dial until
the desired flash mode icon is
displayed in the control panel
(0 175). ~ button
Metering selector
5 FS.6 p ..0 (co [ :.
Main command
dial
D.G 1m [[ H]
Control panel
171