Nikon D300S - Page 311

II. -. -~ ash_~_tLI1~~~!:~~fla.~ _
~ Commander mode
~~-w-
; Mode Camp.
~ Built-in flash IDI; ~
II Group A lUI ~
&I Group B lUI ~
.. Channel 0 CH
.. ~Move (~)Set (QK)OK
II Commander Mode
Use the built-in flash as a master flash controlling one or more
remote
optional 5B-900, 5B-800, 5B-600, or 5B-R200 flash units in
up to two groups (A and B) using advanced wireless lighting.
Selecting this option displays the menu
shown at right. Press ~ or ~ to highlight the
following options, • or'" to change.
Option
Built-in
flash
Description
Choose a flash mode for the built-in flash (commander flash).
M
M
; ..•. --- ,
-",' ._-- .. -. . .. _.. - . ..
TTL i-TTL mode. Choose flash compensation from values between
+3.0 and -3.0 EV in increments of'l3 EV .
. ". - - "'. - .. - .. "~'
Choose the flash level from values between 1/1 and 1/128
('/128 of full power).
~ -. --. --".,,-.' .-. -- - -. - -'. "... , ." - -- ., -
The built-in flash does not fire, but the AF-assist illuminator
lights. The built-in flash must be raised so that it can emit
monitor pre-flashes.
'". - - _. ~. _. "0' • ". _ •. _. ' .• ,~ _. , _.. •• ~ __
Group A Choose a flash mode for all flash units in group A.
. -.'. .-. --. _. . --'-.- ',-.- - ---', '.-. '. ~ '.'. _. ~ . .'--. - '.- ,-,. - --- - _ .. -. -- .. -. '-~ .- -. . -.,-.
TTL :i-TTL mode. Choose flash compensation from values between
+3.0 and -3.0 EV in increments of'l3 EV .
.-_--- -... ,-
Auto aperture (available only with 58-900 and 58-800 flash
AA units). Choose flash compensation from values between +3.0
.and -3.0 EV in increments of '13 EV.
--' .. _- - ~'.' ~.---- ,.~_._.- .. ,_._--_." .•.•.. ,.. - ... _-.. ~. - - -.- -. .-
Choose the flash level from values between 1/1 and 1/128
('/128 of full power).
____ .~ .. ·" '4" .- __ ."."._. __ .'." . __ , •.•• . "_,_ • __ "._
.The flash units in this group do not fire.
Choose a flash
mode for all flash units in group 8. The options
Group B
available are the same as those listed for Group A, above.
Channel Choose from channels 1-4. All flash units in both groups must
be set to the same channel.
285