3-54
3
S-O
Press the [REC] or [ENT] key record the
point. A default PT is shown based on the
previously recorded point number plus
“Add constant” (See p.3-92).
After recording the point, it returns to the
observation screen. When the [ESC] key
is pressed, it returns to the PT/CD/R input
screen. The PT is defaulted to the
previous point plus one if you input the
stakeout point by point.
When you selected a point from a List, it
returns to the same List until all points in
the List have been selected.
Press the [ESC] key to return to the point
input screen.
ＭＰ，１２５，ＦＥＮＣＥ１
ＭＰ，１２８，ＦＥＮＣＥ２
ＭＰ，１５３，ＦＥＮＣＥ
ＭＰ，２０６，ＦＥＮＣＥ１ ↓
Ｉｎｐｕｔ Ｓ－Ｏ Ｐｏｉｎｔ
ＰＴ：１００２
■
ＣＤ：
Ｌｓｔ Ｓｔｋ
“Add Constant” is defaulted to 1000 in MENU/3:Sett/ 7:S-O. (See
p.3-92) It requires an integer that is added to the point number
being staked to obtain a new number for the staked point record.
For example, a staked coordinate point 3 with an Add Constant of
1000 is recorded as stakeout point 1003.
ｄＨＡ→－０°００’１０”
Ｌ → ０．００４ ｍ
ＩＮ ↓ ０．００５ ｍ
ＰＴ：５０２
To Next Page
Loading...
