Nortel BayStack 350 Series - Page 116

Using the BayStack 350 Series 10/100 Autosense Switch
3-8
893-00992-E
SNMP Configuration...
Displays the SNMP Configuration Menu screen (see “
SNMP Configuration” on
page 3-14
). This screen allows you to set or modify the SNMP read-only
community and read-write community strings, enable or disable the
authentication trap for each port, set the IP address of trap receivers, and set
the trap community strings.
System
Characteristics...
Displays the System Characteristics screen (see “
System Characteristics” on
page 3-20
). This screen allows you to view switch characteristics such as the
number of resets and the hardware and firmware version. This screen also
contains three user-configurable fields: sysContact, sysName, and
sysLocation.
Switch Configuration...
Displays the Switch Configuration Menu screen (see “
Switch Configuration” on
page 3-22
). This menu provides the following configuration options: MAC
Address Table, MAC Address-Based Security, VLAN Configuration, Port
Configuration, MultiLink Trunk Configuration, Port Mirroring Configuration, Rate
Limiting Configuration, Display Port Statistics, and Clear All Port Statistics.
Console/Service Port
Configuration...
Displays the Console/Service Port Configuration screen (see “
Console/Service
Port Configuration” on page 3-58).
Spanning Tree
Configuration...
Displays the Spanning Tree Configuration Menu (see “
Spanning Tree
Configuration” on page 3-61). This menu provides the following configuration
options: Spanning Tree Port Configuration, Display Spanning Tree Switch
Settings.
TELNET Configuration...
Displays the TELNET Configuration screen (see “
TELNET Configuration” on
page 3-68
).
Software Download...
Displays the Software Download screen (see “
Software Download” on
page 3-71
).
Configuration File...
Displays the Configuration File Download/Upload screen (see “
Configuration
File” on page 3-74). This screen allows you to store your switch configuration
parameters on a TFTP server. You can retrieve the configuration parameters for
automatically configuring a replacement switch or other switches with the same
parameters.
Network Security...
Displays the Radius Network Security screen (see “
Network Security” on 3-77).
This screen allows you to set up or modify parameters for using the Radius
(Remote Authentication Dial-In User Services) protocol.
Display Event Log
Displays the Event Log screen (see “
Display Event Log” on page 3-79).
(continued)
Table 3-1. Console interface main menu commands
(continued)
Command Description