Nortel BayStack 350 Series - Configuration File; Figure 3-32. Configuration File Download;Upload Screen

Using the BayStack 350 Series 10/100 Autosense Switch
3-74
893-00992-E
Configuration File
The Configuration File Download/Upload screen (Figure 3-32) allows you to
store your switch configuration parameters on a TFTP server. You can retrieve the
configuration parameters and use the retrieved parameters to automatically
configure a replacement switch or a group of switches if required.
You must set up the file on your TFTP server and set the filename read/write
permission to enabled before you can save the configuration paramenters.
Although most configuration parameters are saved to the configuration file,
certain parameters are not saved (see Table 3-33
on page 3-76).
Choose Configuration File (or press g) from the main menu to open the
Configuration File Download/Upload screen.
Figure 3-32. Configuration File Download/Upload Screen
Note:
A configuration file obtained from a donor BayStack 350 switch can
only be used to properly configure other BayStack 350 switches that have the
same firmware revision and model type as the donor switch.
Configuration File Download/Upload
Configuration Image Filename: [ ]
TFTP Server IP Address: [ 0.0.0.0 ]
Copy Configuration Image to Server: [ No ]
Retrieve Configuration Image from Server: [ No ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.