Nortel BayStack 350 Series - Port Mirroring Configuration

Using the BayStack 350 Series 10/100 Autosense Switch
3-48
893-00992-E
Port Mirroring Configuration
The Port Mirroring Configuration screen allows you to configure a specific switch
port to monitor up to two specified ports. You can specify port-based monitoring
or address-based monitoring.
For more information about the port mirroring feature, see “Port Mirroring
(Conversation Steering)” on page 1-45.
Figure 3-22
shows an example of a Port Mirroring Configuration screen where
switch port 12 is designated as the monitoring port for ports 24 and 25.
Choose Port Mirroring Configuration (or press i) from the Switch Configuration
Menu screen to open the Port Mirroring Configuration screen.
Figure 3-22. Port Mirroring Configuration screen
Port Mirroring Configuration
Monitoring Mode: [ -> Port X or Port Y -> ]
Monitor Port: [ 12 ]
Port X: [ 25 ]
Port Y: [ 24 ]
Address A: [ 00-00-00-00-00-00 ]
Address B: [ 00-00-00-00-00-00 ]
Port mirroring configuration has taken effect.
Currently Active Port Mirroring Configuration
---------------------------------------------
Monitoring Mode: -> Port X or Port Y -> Monitor Port: 12
Port X: 25 Port Y: 24
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.