Nortel BayStack 350 Series - Trunk Configuration Screen Examples

Getting Started
893-00992-E
1-29
Trunk Configuration Screen Examples
This section shows examples of the Trunk Configuration screens for the client/
server configuration example shown in Figure 1-17
. The screens show how you
could set up the trunk configuration screens for switches SW1 to SW4. For more
information about configuring trunks, see “Before Configuring Trunks
” on
page 1-40
.
Trunk Configuration Screen for Switch SW1
Switch SW1 is set up with one server trunk configuration (S1) and four
inter-switch trunk configurations (I1, I2, I3, and I4).
Setting up the Server Trunk Configuration for SW1:
To set up the server trunk configuration, you choose Server Trunk
Configuration from the MultiLink Trunk Configuration Menu screen
(Figure 1-18
).
Figure 1-18. Choosing the Server Trunk Configuration screen
MultiLink Trunk Configuration Menu
Inter-Switch Trunk Configuration...
Server Trunk Configuration...
Trunk Utilization...
Return to Switch Configuration Menu
Use arrow keys to highlight option, press <Return> or <Enter> to select option.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.