Nortel BayStack 350 Series - Logout; Figure 3-39. Password Prompt Screen

Using the Console Interface
893-00992-E
3-83
Logout
The Logout command (accessed from the main menu) allows a user working at a
password-protected console terminal or in an active TELNET session to terminate
the session.
The Logout command works as follows:
• If you are accessing the BayStack 350 switch through a TELNET session, the
Logout command terminates the TELNET session.
• If you are accessing the BayStack 350 switch through a password-protected
console terminal (connected to the console/service port on the switch), the
Logout command displays the console-terminal password prompt
(Figure 3-39
). You must enter the correct password to access the CI.
Figure 3-39. Password prompt screen
You can specify whether a password is required for the TELNET session or the
console terminal using the Console/Service Port Configuration screen (see
“
Console/Service Port Configuration” on page 3-58).
If the console terminal is not password protected, the system ignores the Logout
command.
BayStack Model 350T HW:Rev
x FW:V x.xx SW:V x.x.x
Password: [ *************** ]
Enter Password: