Nortel BayStack 350 Series - Setting Security Passwords

Using the BayStack 350 Series 10/100 Autosense Switch
3-60
893-00992-E
Setting Security Passwords
Setting security passwords for your switch requires setting the appropriate
parameter values in two screens:
• Console Service Port Configuration screen (page 3-58
)
• Radius Network Security screen (page 3-77
)
This section provides a matrix you can use to determine the proper values to enter
according to your security requirements. To use the matrix, do the following:
1.
Determine your console security requirements (Tabl e 3 -2 3).
2.
Determine your TELNET sessions security requirements (Ta bl e 3- 24).
Caution:
If you change the system-supplied default passwords, be sure to
write the new passwords down and keep them in a safe place. If you forget the
new passwords, you cannot access the console interface. In that case, contact
Nortel Networks for help.
Default secure
Range Any ASCII string of up to 15 printable characters
Table 3-23. Determining Console Security Requirements
Security requirement: Choose one of the following values
1
:
1
C = Console, L = Local, N = None, R = RADIUS.
Console None Local RADIUS
(CN) (CL) (CR)
Table 3-24. Determining TELNET Sessions Security Requirements
Security requirement: Choose one of the following values
1
:
1
L = Local, N = None, R = RADIUS, T = TELNET.
TELNET None Local RADIUS
(TN) (TL) (TR)
Table 3-22. Console/Service Port Configuration screen fields
(continued)
Field Description