Nortel BayStack 350 Series - SNMP Community Strings and Trap Addresses; Figure 3-5. SNMP Community Strings and Trap Addresses Screen

Using the BayStack 350 Series 10/100 Autosense Switch
3-16
893-00992-E
SNMP Community Strings and Trap Addresses
The SNMP Community Strings and Trap Addresses screen (Figure 3-5) allows
you to set or modify your SNMP configuration parameters.
Choose SNMP Community Strings and Trap Address (or press c) from the SNMP
Configuration Menu screen to open the SNMP Community Strings and Trap
Addresses screen.
Figure 3-5. SNMP Community Strings and Trap Addresses screen
Table 3-4 describes the SNMP Configuration screen fields.
SNMP Community Strings and Trap Addresses
Read-Only Community String: [ public ]
Read-Write Community String: [ private ]
Trap #1 IP Address: [ 0.0.0.0 ]
Community String: [ ]
Trap #2 IP Address: [ 0.0.0.0 ]
Community String: [ ]
Trap #3 IP Address: [ 0.0.0.0 ]
Community String: [ ]
Trap #4 IP Address: [ 0.0.0.0 ]
Community String: [ ]
Authentication Trap: [ Enabled ]
AutoTopology MIB: [ Enabled ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.