Nortel BayStack 350 Series - Appendix D Default Settings

893-00992-E D-1
Appendix D
Default Settings
Table D-1 lists the factory default settings for the BayStack 350 switch.
Table D-1. Factory default settings for the BayStack 350 switch
Field Default setting Appears in this CI screen
BootP Request Mode BootP When Needed IP Configuration
In-Band IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
Read-Only Community String public SNMP Community Strings and Trap
Addresses
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
AutoTopology MIB Enabled
Link Up/Down Trap Status Enabled SNMP Port Link Up/Down Trap Options
sysContact Zero-length string System Characteristics
sysName Zero-length string
sysLocation Zero-length string
(continued)