Using the Console Interface
893-00992-E
3-11
Table 3-2 describes the IP Configuration screen fields.
Table 3-2. IP Configuration screen fields
Field Description
BootP Request Mode
One of four modes of operation for BootP. (See “
Choosing a BootP Request Mode”
on page 3-12
for details about the four modes.)
Default BootP When Needed
Range BootP When Needed, BootP Always, BootP Disabled, BootP or
Last Address
Configurable
Column header for the user-configurable fields in this screen.
In Use
Column header for the read-only fields in this screen. The read-only data displayed
in this column represents data that is currently in use.
Last BootP
Column header for the read-only fields in this screen. The read-only data displayed
in this column represents data obtained from the last BootP reply received.
In-Band IP Address
The in-band IP address of the BayStack 350 switch.
Default 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal point
In-Band Subnet Mask
The subnet address mask associated with the in-band IP address shown on the
screen.
Network routers use the subnet mask to determine the network or subnet address
portion of a host’s IP address. The bits in the IP address that contain the network
address (including the subnet) are set to 1 in the address mask, and the bits that
contain the host identifier are set to 0.
Default 0.0.0.0 (no subnet mask assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal point
Default Gateway
The IP address of the default gateway.
Default 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal point
To Next Page