Using the Console Interface
893-00992-E
3-75
Table 3-32 describes the Configuration File Download/Upload screen fields.
Table 3-32. Configuration File Download/Upload Screen Fields
Field Description
Configuration Image
Filename
The file name you have chosen for the configuration file. Choose a meaningful
file name that will allow you to identify the file for retrieval when required. The file
must already exist on your TFTP server and must be read/write enabled.
Default Zero-length string
Range An ASCII string of up to 30 printable characters
TFTP Server IP Address
The IP address of your TFTP load host.
Default 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal point
Copy Configuration
Image to Server
Specifies whether to copy the presently configured switch parameters to the
specified TFTP server (default is No). Use the spacebar to toggle the selection
to Yes.
Press [Enter] to initiate the process.
Default No
Range Yes, No
Retrieve Configuration
Image from Server
Specifies whether to retrieve the stored switch configuration parameters from the
specified TFTP server (default is No). If you choose Yes, the download process
begins immediately and, when completed, causes the switch to reset with the
new configuration parameters.
Use the spacebar to toggle the selection to Yes. Press [Enter] to initiate the
process.
Default No
Range Yes, No
To Next Page
Loading...
