Using the Console Interface
893-00992-E
3-33
Instead, you can highlight the field, and then enter +14 [Return]. The existing field
keeps the previous list, and adds the new port number (14) between ports 12 and
16.
(If you had chosen to add port 15 to the existing port number list, the field accepts
the new port 15 but shows the new port number list field as: 1, 3, 5, 9, 12, 15-16.)
Removing a Port from an Existing Port Number List:
To remove a port from the port number list, use the minus sign (-) character
instead of the plus sign (+) character as described above.
Copying an Existing Field into an Adjacent Field:
Another accelerator key you can use is the period (.) character. This character is
used to copy a previously entered field into the field directly next to it.
For example, to copy the entire port number list 1, 3, 5, 9, 12, 16 (shown in
Figure 3-12
on page 3-31) into the next field (entry 7):
1.
Enter a MAC address into the MAC Address field.
2.
Highlight the (blank) Allowed Source Port (s) field.
3.
Enter the period character (.) and press [Return].
The port number list from the previous entry is copied into the new field.
These accelerator keys work only on fields that require entering a list, which
includes the MAC Address Security Configuration screen and the MAC Address
Security Table screen.
To Next Page
Loading...
