Nortel BayStack 350 Series - Page 146

Using the BayStack 350 Series 10/100 Autosense Switch
3-38
893-00992-E
Status
Allows you to disable any of the switch ports. You can also use this field to control
access to any switch port.
Default Enabled
Range Enabled, Disabled
Link
A read-only field that indicates the current link state of the corresponding port, as
follows:
• Up: The port is connected and operational.
• Down: The port is not connected or is not operational.
Autonegotiation
1
When enabled, sets the corresponding port speed to match the best service provided
by the connected station, up to 100 Mb/s in full-duplex mode.
Default Enabled
Range Enabled, Disabled
Speed/Duplex
2
Allows you to manually configure any port to support an Ethernet speed of 10 Mb/s or
100 Mb/s, in half- or full-duplex mode.
Default 100Mbs/Half (when Autonegotiation is Disabled)
Range 10Mbs/Half, 10Mbs/Full, 100Mbs/Half, 100Mbs/Full
1
You cannot modify this field for the Model 350F-HD and Model 350F 100BASE-FX fiber optic ports.
2
The Model 350F-HD and Model 350F 100BASE-FX fiber optic ports can be set to 100 Mbs/Half or 100 Mbs/Full.
Table 3-13. Port Configuration screen fields
(continued)
Field Description