3-1-8. INCH Function (INCH)
The INCH function compensates for positional deviations caused by machine friction, etc., by adding the preset
INCH zone amount (parameter setting no.52) to the target position so that extremely low-speed positioning occurs.
When executing positioning operations for press dies, this function permits corrections for minute deviations caused
by machine wear and deformation, etc.
3-1-9. JOG Function
The JOG function permits positioning to be executed by external inputs, communication, or by key inputs at the
control panel without regard to the target stop position.
To Next Page
Loading...
Need help?
General
