45584901TH Rev.1
5-69 /
Oki Data CONFIDENTIAL
[2C6A] HOST NAME error (No RFC error)
Check if there is an illegal character in the device name.
Delete the illegal character and reset the appropriate device name.
[2C6B] Terminal mail address error
Check the SMTP Authentication method.
Check if there is an illegal character in the Terminal mail address.
Set the correct SMTP Authentication method or delete the illegal character and reset the
appropriateTerminalmailaddress,thenperformthejobagain.
[2C6C] Destination mail address error (No RFC error)
Check if there is an illegal character in the Destination mail address.
DeletetheillegalcharacterandresettheappropriateDestinationmailaddress,thenperform
the job again.
[2C70] SMTP client OFF
Set the SMTP valid and perform the job again.
[2C71] SMTP authentication error
CheckthatSMTPauthenticationmethod,loginnameandpasswordarecorrect,thenperform
authentication again.
[2C72] POP Before SMTP error
CheckthatboththePOPBeforeSMTPsettingandPOP3settingarecorrect,thenperform
authentication again.
[2CC1] Power failure
Check if the power cable is connected properly and it is inserted securely.
Check if the power voltage is unstable.
[6] File sharing related error
[2D10] System access abnormality
[2D32] File deletion failure
[2DA6] File deletion failure
[2DA7] Resource acquiring failure
Delete some files in the shared folder by using Explorer because of automatic/manual file
deletion failure (in case of [2DA6])
Turn the power OFF and then back ON. Perform the job in error again.
If theerror still occurs,rst,check ifthereare no jobs existing andthenperform the HDD
formatting([5]+[C]+[POWER]ON
→
[3]
→
[1]).
[2D11] Insufficient memory
Whentherearerunningjobs,performthejobin erroragainafterthe completion ofthe
runningjobs.Iftheerrorstilloccurs,turnthepowerOFFandthenbackON,andperformthe
job again.
[2D12] Message reception error
[2D13] Message transmission error
Turn the power OFF and then back ON. Perform the job in error again.
To Next Page
Loading...
