Oki MC770 - License Re-Registration Using the One-Time Dongle

45584901TH Rev.1
6-27 /
Oki Data CONFIDENTIAL
6.2.9 Licensere-registrationusingtheone-timedongle
[1] Re-registration when the board is replaced
The license registered using the one-time dongle can be re-registered only in the same
equipment.WhentheCUboardandSRAMboard(forCUboard)arereplaced,followthe
procedures for re- registration given below.
(1) Start up with the Setting Mode (08).
(2) Enterthepassword,andthenpressthe[OK]button.
 (IfthepasswordisnotsetforService,pressthe[ENTER]buttonwithoutentering
anything.)
(3) Keyin[3840],andthenpressthe[START]button.
(4) Pressthe[INSTALL]button.
(5) Installtheone-timedongleintheequipment(theonewhichyouusedforregistering
theselectedlicense),andthenpressthe[OK]button.
(6) Selectthelicensetobeinstalled,andthenpressthe[INSTALL]button.
(7) The screen for notifying that the installation will be started is displayed. Then press the
[YES]button.
(8) After10to40secondshavepassed,thescreenfornotifyingthesuccessofthe
performanceisdisplayed.Thenpressthe[OK]button.Ifthescreenfornotifyinga
failureoftheperformanceisdisplayed,quitthisoperationbypressingthe[CLOSE]
button.Thencheckthattheone-timedongle,whichyouusedforuploadingthe
selectedlicense,isinstalledintheequipment.
(9) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be returned, repeat from step (4). If there are no other
licensestobereturned,pressthe[CLOSE]button,andthenturnthepowerOFF.
Notes:
Thisprocedureisavailableonlywiththeone-timedongleusedforthepreviousregistration,
since the model information registered in it is utilized. Use the same one-time dongle and
theequipmentwhenregisteringthelicense.
[2] Re-registration when the equipment is replaced due to malfunction
Whentheequipmenthastobereplacedduetoamalfunction,returnthelicenseregistered
intheequipmenttotheone-timedongleandregisterittothenewequipmentfollowingthe
procedure below.
Notes:
The license of the IPSec Enabler (GP-1080) cannot be reinstalled. The one-time dongle to
be used is the one for the previous registration of the license. The license is deleted from
theequipmentandisstoredintheone-timedongle.
Do not perform the deletion of PDFA Converter since it is deleted without any return to the
one- time dongle.
(1) Start up with the Setting Mode (08).
(2) Enterthepassword,andthenpressthe[OK]button.
 (IfthepasswordisnotsetforService,pressthe[ENTER]buttonwithoutentering
anything.)
(3) Keyin[3840],andthenpressthe[START]button.
(4) Selectthelicensetobereturned,andthenpressthe[REMOVE]button.
(5) Installtheone-timedongleintheequipment(theonewhichyouusedforuploadingthe
selectedlicense),andthenpressthe[OK]button.