Oki MC770 - Other Errors

45584901TH Rev.1
5-98 /
Oki Data CONFIDENTIAL
5.4 Other errors
5.4.1 Equipmentoperationdisabledaftertheinstallationofoption(s)
Check if the optional board is installed properly.
5.4.2 WirelessLANconnectiondisabled
TheconnectionstateandsettingsoftheWirelessLANcanbecheckedwith[USER
FUNCTIONS]
→
[ADMIN]
→
[WIRELESSLAN]
→
[SETTINGCHECK].
Confirm the settings with the administrator.
• “NICINITIALIZING” doesnotdisappearat thetimeofthepowerbeingturnedONandit
disappearsafter6minuteswiththeNICinitializingtime-out.Inthiscase,theconnectiontothe
WirelessLANdidnotsucceedeventhough“NICINITIALIZING”disappears.
• TheconnectiontotheWirelessLANcannotbemadeiftheAccessPointtobeconnectedis
not found or security settings are not correct.
5.4.3 “InvalidDepartmentCode”isdisplayed
LogintoWebPageasanadministrator,select[Authentication]onthe[UserManagement]tab,
and then check whether Department Setting is enabled or disabled.
Department Setting is enabled:
• LogintoWebPageasanadministrator,select[Authentication]onthe[UserManagement]tab,
and then check User Management Setting.
• Conrmthesettingsof08-3805inthesettingmode.
Department Setting is disabled:
• LogintoWebPageasanadministrator,select[Authentication]onthe[UserManagement]tab,
and then check User Management Setting.
5.4.4 Ethernet disabled in half-duplex communication
TheEthernetofthisequipmentdoesnotsupporthalf-duplexcommunication.
Whentheportsettingoftheswitchisfixedathalf-duplexcommunication,useanyof
10/100/1000Mbps,full-duplexxedcommunicationmodeorauto-negotiationfunction.
Inaddition,selectthesettingoftheequipmentcorrespondingtothatoftheswitch.([ADMIN]>
[NETWORK]>[ETHERNET])
Checkthesetcommunicationspeedasfollowsifrequired:[ADMIN]>[NETWORK]>[ETHERNET]