45584901TH Rev.1
5-71 /
Oki Data CONFIDENTIAL
[2D68] File sharing service not available
Check if the setting of SMB is valid.
[2D69] NetWare service not available
Check if the Netware setting is enabled.
[2DC1] Power failure
Check if the power cable is connected properly and it is inserted securely.
Check if the power voltage is unstable.
[2E10] USB storage system access abnormality
TurnthepowerOFFandthenbackON.Performthejobinerroragain.Iftheerrorstilloccurs,
rst,checkiftherearenojobsexistingandthenperformHDDformatting([5]+[C]+[POWER]
ON
→
[3]
→
[1]).
[2E11] Insufficient memory capacity for USB storage
Ifthereisajobinprogress,performthejobinerroragainafterthejobinprogressisnished.
Iftheerrorstilloccurs,turnthepowerOFFandthenbackON,andthenperformthejobin
error again.
[2E12] Message reception error in USB storage
[2E13] Message transmission error in USB storage
Turn the power OFF and then back ON. Perform the job in error again.
[2E14] Invalid parameter for USB storage
Ifatemplateisbeingused,recreatethetemplate.Iftheerrorstilloccurs,turnthepowerOFF
and then back ON. Perform the job in error again.
[2E15] Exceeding maximum file capacity
Delete some files in the folder. Perform the job in error again.
[2E30] Directory creation failure in USB storage
Check if access privilege to the storage directory is writable. Check if the server or local disk
has sufficient space in its disk capacity.
[2E31] File creation failure in USB storage
Check if access privilege to the storage directory is writable. Check if the server or local disk
has sufficient space in its disk capacity.
[2E32] File deletion failure in USB storage
TurnthepowerOFFandthenbackON.Performthejobinerroragain.Iftheerrorstilloccurs,
rst,checkiftherearenojobsexistingandthenperformHDDformatting([5]+[C]+[POWER]
ON
→
[3]
→
[1]).
[2E33] File access failure in USB storage
Check if access privilege to the storage directory is writable. Check if the server or local disk
has sufficient space in its disk capacity.
[2E40] Image conversion abnormality in USB storage
Turn the power OFF and then back ON. Perform the job in error again. Replace the main
memory and then perform the job in error again.